Files are the tool
of choice to make adjustments when a previous cut didn't come out
just right. They can also be used to round edges, open holes, or
just to remove a little unnecessary material. A fine file set is
required for most scratchbuilding and kitbashing adventures.
Sometimes larger files are required, usually these two will
do. The flat file is called a mill file and is most useful for
removing protrusions from otherwise flat surfaces or edges. The
round file is useful for enlarging holes or converting a drilled
hole into a slot.
© 1999 George Schreyer
Created Dec 4, 1999
Last Updated Dec 4, 1999